Just recording this for anybody that needs it. FME Datainspector shows a CW/CCW (clockwise/counter-clockwise) direction for an arc under the geometry, but this value can't be extracted as a trait using a geometrypropertyextractor and the arcpropertyextractor doesn't list any attribute that return clockwise/counterclockwise.
Solved
Exracting CW/CCW from arc
+22- Supporter
Best answer by todd_davis
The answer is the CW/CCW in the datainspector is derived from the fme_sweep_angle. This attribute is returned as the sweep angle by the arcpropertyextractor. Positive values are counter-clockwise and negatives are clockwise
+22- Supporter
The answer is the CW/CCW in the datainspector is derived from the fme_sweep_angle. This attribute is returned as the sweep angle by the arcpropertyextractor. Positive values are counter-clockwise and negatives are clockwise
+35- Celebrity
todd_davis wrote:
The answer is the CW/CCW in the datainspector is derived from the fme_sweep_angle. This attribute is returned as the sweep angle by the arcpropertyextractor. Positive values are counter-clockwise and negatives are clockwise
@todd_davis - Thanks for sharing!
Reply
Helpful Members This Week
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.