Hello,
I have a workbench pulling features from a table in Dynamics CRM, using VertexCreater into a Geodatabase. Everything seems to be working fine, but when I look at the features in ArcGIS Pro, They seem to be in the right place when I zoom to them using the attribute table, but they are oddly not showing. Does anyone know what can be causing this?
Best answer by morijlumos
I was able to fix it using the Clipper transformer and using a country border layer. Apparently, there were some crazy coordinates coming out of the database that were throwing off the spatial index (i have no proof of this but just assuming) but the points are showing up properly now. 
+54if you inspect the features leaving the GeometryCoercer are they in the right place and do they have geometry?
Yes, It appears they do, but it looks like there's some bad coordinates, not sure if that would make a difference (greendots)
if you inspect the features leaving the GeometryCoercer are they in the right place and do they have geometry?
Hello sorry for the late response, I got pulled to another project for a while, I also tried the GeometryValidator, it is passing everything and they are still not showing.
I was able to fix it using the Clipper transformer and using a country border layer. Apparently, there were some crazy coordinates coming out of the database that were throwing off the spatial index (i have no proof of this but just assuming) but the points are showing up properly now.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
