I'd like to decrease the length of lines by a fixed distances by shortening the line at the end. Is there a way to do that?
Regards,
Bas
Question
Shorten line by fixed distance
Hello
This post is closed to further activity.
It may be an old question, an answered question, an implemented idea, or a notification-only post.
Please check post dates before relying on any information in a question or answer.
For follow-up or related questions, please post a new question or idea.
If there is a genuine update to be made, please contact us and request that the post is reopened.
It may be an old question, an answered question, an implemented idea, or a notification-only post.
Please check post dates before relying on any information in a question or answer.
For follow-up or related questions, please post a new question or idea.
If there is a genuine update to be made, please contact us and request that the post is reopened.
+21- Safer
David right on the Snipper of course
But as I just noticed last week, it's not obvious how to snip from the end.
To Snip from the start you can just enter the number in the Starting Location, but the Ending Locaiton is measure from the start so you need something like this:
@Length()-250
Thank you guys! The snipper will do eactly what I need.
In fact, somtimes I need to cut off the line at the start en somtimes at the end. If I need to cut at the end I will probably use the orientor first to switch start- and endpoints.