I am. try to group all CellValue as you can see I am getting 4881593 records so I need group them please find the workspace
Solved
I try to group the polygon
+5Best answer by dustin
You can use the Dissolver after the RasterCellCoercer, with the group by set to _band{0}.value
+30- Influencer
- Best Answer
You can use the Dissolver after the RasterCellCoercer, with the group by set to _band{0}.value
+30- Influencer
Ahh, you wanted to group the points instead of polygons. In that case, use the Aggregator instead of the Dissolver, and group by the same attribute. In your RasterCellCoercer, you will need to change the Output Cell Geometry from polygon to point.
+30- Influencer
asadamjad wrote:
No i want in polygon not points
Ok, so yes the Dissolver will dissolve the boundaries between like polygons, essentially grouping them. If you want to retain all the boundaries of the polygons, you could use the Aggregator.
+30- Influencer
asadamjad wrote:
i done as you said but its taking to much time to load data 
Make sure 'Enable Feature Caching' is unchecked. Having this checked can drastically increase processing time.
+5dustin wrote:
Make sure 'Enable Feature Caching' is unchecked. Having this checked can drastically increase processing time.
i did but same result its take 30 mins to run the workspace and the around 45 mins to load the datat
Reply
Rich Text Editor, editor1
Editor toolbars
Press ALT 0 for help
Helpful Members This Week
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.