Hi,
this might be odd question but here it goes:
Is it possible to explode hatch paterns to its geometries. For example, if some polygon is hatched with horizontal lines can I get those lines?
Thank you.
+4- Contributor
itay wrote:
Try the deaggregator transformer.
hatches.jpg
Looks like your hatch is a reference to a pattern called "ANSI31" that is defined in an external .pat file and not stored in your drawing. That's why you don't see it in the Inspector.
You can find the definition of the ANSI31 hatch pattern here:
http://help.autodesk.com/view/ACD/2016/ENU/?guid=GUID-A6F2E6FF-1717-44B6-A476-0CA817ADD77E
It should be possible to re-create it as lines in FME and then clip it using your polygons.
Reply
Rich Text Editor, editor1
Editor toolbars
Press ALT 0 for help
Helpful Members This Week
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.