I ran an FME workbench to create gdb for spatial and non-spatial data (approximately 25 data layers). The process ran successfully and created gdb which has the expected size. Now, when I try to open the gdb, it only shows one table. Although, the log file shows that it reads and writes all the layers successfully. If someone has faced the same issue, I really appreciate your insight on the same.
+54
Any errors in de FME translation log?
What do you use to check the gdb?
If you use ArcMap or ArcGIS Pro, did you reload after the FME process is finished?
If you read the result using FME Desktop, do you see the data?
nielsgerrits wrote:
Any errors in de FME translation log?
What do you use to check the gdb?
If you use ArcMap or ArcGIS Pro, did you reload after the FME process is finished?
If you read the result using FME Desktop, do you see the data?
No error in the log file. and when I open the gdb in ArcMap, it shows only 1 layer instead of 25.
+54sal wrote:
No error in the log file. and when I open the gdb in ArcMap, it shows only 1 layer instead of 25.
Warnings?
Same. It reads one table instead of 25. and the file size of the gdb is over 1 GB, though the table size is less than 100 kb.
+54sal wrote:
Same. It reads one table instead of 25. and the file size of the gdb is over 1 GB, though the table size is less than 100 kb.
I surrender :) hard to tell without workspace.
Reply
Rich Text Editor, editor1
Editor toolbars
Press ALT 0 for help
Helpful Members This Week
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.