Anybody have idea about Geometry characteristics of road each 10 meters with Fields of Geometry table with output Shapefile
1)Road
2)Segment
3)Length- in meters
4)Shoulder- in decimeters
5)Carriageway- in decimeters
6)Additional lane- in decimeters
7)Slow lane- in decimeters
8)Platform- in decimeters
9)Median- in meters
10)No of lanes
11)Slope- % of a pavement
12)Camber- Cross slope (%) of platform
13)Radius of curvature
14)Geographical coordinates(lat & long)
15)UTM coordinates(x,y,z)
Best answer by erik_jan
Multiple processes involved here, but I will list some to get you started:
Densifier transformer to get a vertex at every 10 meters, followed by
Chopper transformer to create the 10 meter road segments.
Length calculated by LengthCalculator transformer
Coordinates to attribute by CoordinateExtractor transformer
Coordinate attribute converted to UTM by AttributeReprojector transformer
Hope this helps getting you on the right track.
+18Multiple processes involved here, but I will list some to get you started:
Densifier transformer to get a vertex at every 10 meters, followed by
Chopper transformer to create the 10 meter road segments.
Length calculated by LengthCalculator transformer
Coordinates to attribute by CoordinateExtractor transformer
Coordinate attribute converted to UTM by AttributeReprojector transformer
Hope this helps getting you on the right track.
Multiple processes involved here, but I will list some to get you started:
Densifier transformer to get a vertex at every 10 meters, followed by
Chopper transformer to create the 10 meter road segments.
Length calculated by LengthCalculator transformer
Coordinates to attribute by CoordinateExtractor transformer
Coordinate attribute converted to UTM by AttributeReprojector transformer
Hope this helps getting you on the right track.
I got some ideas with your suggestions, but I need automatic width calculation for road characters (for Eg: From Road edge to other corresponding parallel lines)
Multiple processes involved here, but I will list some to get you started:
Densifier transformer to get a vertex at every 10 meters, followed by
Chopper transformer to create the 10 meter road segments.
Length calculated by LengthCalculator transformer
Coordinates to attribute by CoordinateExtractor transformer
Coordinate attribute converted to UTM by AttributeReprojector transformer
Hope this helps getting you on the right track.
Multiple processes involved here, but I will list some to get you started:
Densifier transformer to get a vertex at every 10 meters, followed by
Chopper transformer to create the 10 meter road segments.
Length calculated by LengthCalculator transformer
Coordinates to attribute by CoordinateExtractor transformer
Coordinate attribute converted to UTM by AttributeReprojector transformer
Hope this helps getting you on the right track.
sample1.dwg.fmw
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
