What is the best way with FME to merge adjacent and coplanar 3D polygons?
Regards
Asher
Solved
Merge coplanar and adjacent polygons
Hi all,
Best answer by jonathan
Hi Asher,
View originalI'm not over-familiar with 3D, but I'm not sure you can. Dissolver would be the obvious choice but it only handles 2D.
SolidBuilder maybe?
Maybe some fancy conversion into a Surface or TIN or something similar and then back?
Hopefully someone with more knowledge of 3D will chip in.
Cheers,
Jonathan
This post is closed to further activity.
It may be a question with a best answer, an implemented idea, or just a post needing no comment.
If you have a follow-up or related question, please post a new question or idea.
If there is a genuine update to be made, please contact us and request that the post is reopened.
It may be a question with a best answer, an implemented idea, or just a post needing no comment.
If you have a follow-up or related question, please post a new question or idea.
If there is a genuine update to be made, please contact us and request that the post is reopened.
Hi Asher,
I'm not over-familiar with 3D, but I'm not sure you can. Dissolver would be the obvious choice but it only handles 2D.
SolidBuilder maybe?
Maybe some fancy conversion into a Surface or TIN or something similar and then back?
Hopefully someone with more knowledge of 3D will chip in.
Cheers,
Jonathan
Helpful Members This Week
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.