Hi guys,
As question says, I have a set of circles which I have to convert to either hexagon or octagon. Tried googling resault and didn't find any help.
Any ideas?
Untested, but perhaps try the ArcEstimator to convert the circles into circular arcs, then use the ArcStroker and set the number of interpolated edges to either 6 or 8.
Did a short test:
david_r wrote:
Untested, but perhaps try the ArcEstimator to convert the circles into circular arcs, then use the ArcStroker and set the number of interpolated edges to either 6 or 8.
Did a short test:
That actually worked!!! I tried ArcStroker but without ArcEstimator and couldn't get good resault.
Thank you very much
Reply
Rich Text Editor, editor1
Editor toolbars
Press ALT 0 for help
Helpful Members This Week
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.