Hi,
is it possible to convert HTML page to jpg file.
Thank you, cheers.
Solved
Convert HTML page to image file
+4- Contributor
Best answer by dmitribagh
Hi @zzupljanin
Here is the transformer to convert HTML to images. Note that we only create a wrapper to call the tool within FME and have no control over the image creation.
https://hub.safe.com/transformers/html2imageconvertor
I'm not sure FME is the best tool for that. However there are a lot of utilities out there specifically for this, you will find many of them if you google e.g. "convert html to image".
If necessary, you could probably automate such a tool using FME.
+16- Supporter
Hi @zzupljanin, I agree with @david_r on the issue, you could try to automate it via FME and PhantomJS
Good luck and have fun!
+7Hi @zzupljanin,
I suggest you take a look at the next website where you can download a command line tool to make the conversion. Using a SystemCaller you can call this tool via FME.
https://www.coolutils.com/HTML-JPG-CommandLine
Good Luck!
+15- Safer
@zzupljanin
I made a custom transformer that turns HTMl into a raster using WKHTML2Image command line tool, I can publish later this week (and update this thread with the link).
I published a similar transformer that turns html into a PDF last week:
+15- Safer
- Best Answer
Hi @zzupljanin
Here is the transformer to convert HTML to images. Note that we only create a wrapper to call the tool within FME and have no control over the image creation.
https://hub.safe.com/transformers/html2imageconvertor
Hi,
i tried phantomjs to get an image of an url. Well, it works perfektly when running the workbench via the "run"-button. but the SystemCaller fails to execute, when the Workbench is run from within a batchfile as a scheduled task.
Here is my setup for the SystemCaller...
Any hints????
+43- Safer
stefangiese wrote:
Hi,
i tried phantomjs to get an image of an url. Well, it works perfektly when running the workbench via the "run"-button. but the SystemCaller fails to execute, when the Workbench is run from within a batchfile as a scheduled task.
Here is my setup for the SystemCaller...
Any hints????
I'll also note that it sounds like you are reading an image from a URL. You can do that directly with the HTTPCaller and there would be no issue of using the SystemCaller.
Anyway, just to mention that you might get a better response if you post this as a new question, rather than a comment on another one.
Hope this helps
Mark
Reply
Rich Text Editor, editor1
Editor toolbars
Press ALT 0 for help
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.