Line (ShapeFile)
Lidar (.XYZ)
I would like to have Z on the shapefile but split featureline when i have a difference (like 5m on Z) or simply put a Begining Z or End Z.
I would like to produce 3D feature and have the profile from this.
Question
How to assign elevation variation from Lidar to shapefile / drap elevation on feature line.
How to assign elevation variation from Lidar to shapefile / drap elevation on feature line.
+15- Contributor
You could use ContourGenerator to create contours from the Lidar points.
Then LineOnLineOverlayer or Intersector wiht the Lines from your shapefile.
( you might need a GeometryValidator after and if you use an Intersector)
+15- Contributor
If u want to use a Begining and End Z you can use a AreaBuilder (before the intesector or LineOnlIne) and extract the bounds using a BoundsExctractor.
If u want all contours to be built to areas, you can use a Hullaccumulator, extender and intersector.
Reply
Rich Text Editor, editor1
Editor toolbars
Press ALT 0 for help
Helpful Members This Week
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.