Question
small world - inside world (CAD to SW)
+2- Contributor
i would like know what can i do to pass dwg files to small world. i have a trench in small wolrd and i could know what can i do to pass some elements define in CAD inside trench. i know that these elements would have the same inicial and finish point that trench. but i don´t know what can i do to put these elements inside the trench, thanks for all.
Hi: If you want to learn a little more about FME & Smallworld you can start with this article in fmepedia (http://fmepedia.safe.com/articles/FAQ/FME-Smallworld-configuration-options). This describes the choices you have in FME for reading or writng Smallworld data.
We also have FME for Smallworld training materials available that you can work through: FME for Smallworld Training (http://www.safe.com/learning/training/resource-center/smallworld/) . This resource page also links to a couple of webinars we presented on working with FME and Smallworld.
+2- Contributor
I do a workout in September and the inner world of things not talked about. I hope to learn with the links you provided me, thanks
Reply
Most helpful members this week
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.