Question
connect points
I hav a set of points (948). I need to connect all points to all points ([P1,P2; P1,P3;...P1,P948], [P2,P1; P2,P3...P2,P948]...[P948,P1,...P948,P947] and so on). Would be great if I could keep the attributes too. Any ideas? We have connected to sets of point before trough cloning. I tried to understand the answers to "Connect all From points to all To points in FromToBuilder" but my lack of experience makes it difficult to make thie suggested workflow.
+11- Contributor
Hi,
I have not understood the question...
Does that mean Point1 should connect with Point2 with Line?
Pratap
Pratap,
All points shold have connection with a line to each other. All points should have 947 connections in the end.
Regards Caroline
+11- Contributor
Hi Caroline,
I understood that the input point/s should connect to remaining points in the input with a line.
I have taken 11 points as input and performed with the below script...
Kindly check from your end.
Hope it meets your requirement...
Pratap
+15- Contributor
If you want to connect all poijnts to all points in 1 set of points.
Use a featuremerger with supplier=requestor= 1 (or any value)
Proces duplicate supliers, and enter a listname.
CoordinateExtractor on both before u feed them to the merger. Give for instance the Supplier points S_x,S_y and Requstor points R_x,R_y.
Explode list after that.
Then two Vertexcreators, one "create point" and other "add point"
Hi,
Another approach using the NeighborFinder of FME 2015.0+.
If you set "0" to the "Number of Neighbors to Find" parameter and specify the "Close Candidate List Name", the NeighborFinder (Candidates Only mode) collects every neighbors and creates a list containing their coordinate values.
# The NeighborFinder could be relatively efficient.
Takashi
Reply
Rich Text Editor, editor1
Editor toolbars
Press ALT 0 for help
Helpful Members This Week
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.