I have sent you a zip file with workbench and dwg file.
This is the result I get. Almost correct.
You can see in this picture that some lines are missing. Anyone have any ideas how to solve this?
Question
CAD polyline to polygon. Some polylines don't create areas even though they should.
+1I have the problem that some areas don't become polygon. Don't know why. I tried using snapper and line closer but that did not work. The polylines need to remain as they are in the dwg file.
+1
+15- Contributor
Use a geometryfilter on the autocad file.
Then a intersector followed by a snapper (endpoint 0.1)
Extender 0.1, strechted. Again intersector then areabuilder.
This will build all the area's.
+1gio wrote:
Use a geometryfilter on the autocad file.
Then a intersector followed by a snapper (endpoint 0.1)
Extender 0.1, strechted. Again intersector then areabuilder.
This will build all the area's.
Best regards
Jesper
Reply
Rich Text Editor, editor1
Editor toolbars
Press ALT 0 for help
Helpful Members This Week
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.