Create vertice in the middle of existing vertice

Hi @felixderglueckl, on creating the new nodes I would do the following:

pointonlineoverlayer on the existing nodes and lines > calculate the resulting segments length > adding a new point half way the length> again pointonlineoverlayer with the new nodes and original lines > grouping/aggregating the lines to form the new geometry.

Just an idea, hope it helps.

What I would do:

If centerpoints needed.

- add UUID's to original lines

- add UUID's to original lines

Are you hoping for lines or points at the end of this? The diagram indicates you want start and end points but your list doesn't include end points at the end of line

You could simply use the old table to either snip, chop or build the linepieces.

Then snip at 50/50 and enumerate.

You can also insert them using a attribute creator to create the coordinateset.

Can also be done using a variable setter and retriever.

Then create the lines using 2 vertexcreators and then use snipper at 50/50 to create the point.

Then u can recreate the line using a pointconnector. (grouped by line id )

I would do this:

Chop the lines into segments (Chopper, with 2 vertices).

Use CenterpointReplacer to create the halfway points.

Use the PointOnLineOverlayer to enter the halfway points into the lines.

Use the LineJoiner to recreate the lines from the segments.