Trace a single feature through a workbench

Thanks, I shall look into that later (youtube is blocked at work).

 

 

For now I shall just seperate that feature using a tester; not sure why I didn't think of that first!

With complex workflows I usually have a Tester or Sampler right after the features have loaded. That way I can stop all features except certain ID-s that I want to trace further on in the workspace. When I see where they run away I usually add an Inspector where I think the issue is.

 

 

I havent used the "Run with Inspection" alot, because then I usually have to disable the Inspection-points I do not want to use, it seems easier to disable (or actually delete) Inspectors when you have solved an issue (to tidy up the workspace).