I would like to iterate through a table based on a list of values. This is the process I would like to automate:
Filter the table on a value then add an attribute and BulkAttributeRenamer. I have 20 values so I'd like to be able loop through the table for each value rather than have a set of transformers for every value.
Best answer by ebygomm
It's not 100% clear what you're trying to do. Perhaps this sort of workflow is what you're aiming for?
The only change if you have 20 values would be additional attributes to expose in the AttributeExposer
@vcarr2005 Can you attach a small example dataset. It looks like you should be able to do this in series
+31It's not 100% clear what you're trying to do. Perhaps this sort of workflow is what you're aiming for?
The only change if you have 20 values would be additional attributes to expose in the AttributeExposer
Thank you @ebygomm! This is exactly what I needed. I had created something similar but I didn't have the Aggregator configured correctly.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
