I have a series of user parameters that will display when I use preview but when I run the workspace the last one won't display. I can't see any options where a parameter wouldn't be visible when running the workspace. Is there a limit to the number of user parameters that can be set?
+2
It's definitely checked.
Userlevel 3
+26
- Influencer
- 589 replies
-
4 May 2022
It's definitely checked.
@chris28 By chance, are you only running a certain section of the workbench with Enable Feature Caching checked? When doing that, it will only display the parameters needed to run to that specific point.
+2
@chris28 By chance, are you only running a certain section of the workbench with Enable Feature Caching checked? When doing that, it will only display the parameters needed to run to that specific point.
No, I'm running the entire workspace.
Userlevel 2
+19
- Supporter
- 142 replies
-
5 May 2022
Maybe also check that the Run with Prompt is on.. when you run the entire workspace it should ask for the 'published' user parameter
Reply
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.