+5
I am trying to generate centerlines from parallel line pairs which are transformed into bounding boxes, then areas. This works but the centerlines do not extend all the way to the edge of the area/bounding box:
There does not seem to be any settings in either bounding box, area builder, or centerline replacer to change this. Am I going to have to add a snapper? Any reason why it does not go to the edge?
Thanks,
Best answer by larue
View original
+5
Here is a possible answer using neighbor finder and line extender, with line length set to the distance:
+30
Here is a possible answer using neighbor finder and line extender, with line length set to the distance:
Nice @larue
+5
I have also had some good luck with the SmartCleaner. You need to play around with the parameters, but it will extend to the edges.
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.
