How to seperate contours based on Elevation.Ex : we have 0.5 m contours(0.5m,1m,1.5m,2m,2.5m etc...).I need 2m contours from the above 0.5m contour like(2m,4m,6m etc).
Any tool is there for sepetate the contours
Userlevel 2
+17
- Contributor
- 7538 replies
-
18 September 2013
Hi,
If the contour features don't have elevation value as attribute, you can use the ElevationExtractor to extract z-value of each feature.
Then, see this similar question.
Choosing contour of same interval
http://fmepedia.safe.com/AnswersQuestionDetail?id=906a0000000coeuAAA
Takashi
You could always start with
- TestFilter - Filter on Elevation >= 2 (m)
- Sorter (Numeric, Ascending)
- Sampler
- Sample every Nth Feature
- Use 4 (if they are every 1/2 meter apart)
Regards,
Mattt
Thanks for all ur reply
Reply
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.