Converting Autocad Surface to a surface?
Folks I have an An autocad_surface that is listed as a fme_aggregate. Want to convert it to a surface via something like numericrasterizer. However its only doing the line edges of the triangles - and not the flat surfaces. Any thoughts? Should i run through deaggregator first ?
@pilgrimjake. Hi, have u solved yr issue? bumped into the same trouble, so would appreciate your help... Cheers!
Userlevel 4
+25
- Safer
- 2399 replies
-
28 November 2016
@pilgrimjake. Hi, have u solved yr issue? bumped into the same trouble, so would appreciate your help... Cheers!
+3
Apart from deaggregating, try surfacefootprintreplacer. (works without aggregating too)
Though in case of donuts you should deaggregate, surfacefootprint replace and then clip to retain the hole(s).
Reply
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.