Is there a transformer that will assign an elevation value interpolated from a set of contour lines?
Best answer by takashi
View originalIs there a transformer that will assign an elevation value interpolated from a set of contour lines?
Best answer by takashi
View originalHi @e_blair, if the contour lines are 3D line features, the SurfaceDraper might help you. Send the contour lines to the Points/Lines port, send the question point to the DrapeFeatures port, and set a preferable tolerance to the Surface Tolerance parameter. The resulting point will have z-coordinate interpolated based on the contour lines.
Hi @e_blair, if the contour lines are 3D line features, the SurfaceDraper might help you. Send the contour lines to the Points/Lines port, send the question point to the DrapeFeatures port, and set a preferable tolerance to the Surface Tolerance parameter. The resulting point will have z-coordinate interpolated based on the contour lines.
Interesting.. will give this a try. Thanks! Ed
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.