The sliverremover transformer is configured with priority setting 0,1,2 for different areas. Idea was to keep area with the value 0 unchanged after running the workspace. But this is not the case. value 0 is also changed in some occasions. How can I be shure to keep the areas with this value untouched?
Why is the area with value 0 not preserved as is when using the sliverremover with priority 0,1,2?
Userlevel 2
+12
- Contributor
- 2177 replies
-
3 August 2016
Can you use a Tester in front of the SliverRemover to filter out the priority 0 and bypass the SliverRemover?
Reply
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.