Does anybody know if it's possible to use a dwg template with a block and then set parameters in FME so the block is 3D-rotated in the resulting dwg-file?
Autocad Block - possibility to set inclination on individual blocks?
+3
I'm not sure whether this can be done with FME.
However if you AutoCAD you could try the function ROTATE3D, which would allow to rotate a block object. If you read the saved drawing with the 3D rotated block (and preferably a not 3D rotated block), you can look into the Format Attributes to see whether there is a difference there.
Hope this helps you solve your challenge.
- Contributor
- 91 replies
-
26 March 2018
I'm not sure whether this can be done with FME.
However if you AutoCAD you could try the function ROTATE3D, which would allow to rotate a block object. If you read the saved drawing with the 3D rotated block (and preferably a not 3D rotated block), you can look into the Format Attributes to see whether there is a difference there.
Hope this helps you solve your challenge.
Reply
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.