I have a .dbf table with X, y and Z coordinates. I need to convert this to a dxf file with z-coordinate. How do I do that?
I'm quite a newbee in FME, but that's not surprising I think.
Joost
Userlevel 4
+25
- Influencer
- 3337 replies
-
6 February 2013
You can use a 3DPointReplacer to create 3D points out of your DBF records, then write that to DXF.
+10
- Contributor
- 577 replies
-
6 February 2013
Or a 3DForcer with the attribute set to Z might be useful to know about too...
Thanks!
Reply
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.